How to Use the Lost Mary BM600 Prefilled Pod KitUpdated 3 hours ago

The Lost Mary BM600 Prefilled Pod Kit is a rechargeable, draw-activated device designed as a direct, reusable replacement for the original BM600 disposable. It uses the same flavours and the same familiar shape, but with a 360mAh rechargeable battery and snap-in replacement pods so you never have to throw away the whole device. Each pod contains 2ml of 20mg nicotine salt e-liquid and delivers up to 600 puffs.

Get Set Up in 3 Simple Steps

Lost Mary BM600 pod kit diagram showing device features and setup instructions

Before you start. The BM600 has two small things to remove before first use. Pull the silicone plug out from the top of the pod, and peel the sticker off the base of the device. Both are there to protect the device in transit.

Remove all packaging from the device and pod, pull the silicone plug from the pod mouthpiece, and peel the sticker from the base of the device.
Insert the pod into the top of the device. The magnets will pull it into place with a click.
Inhale as you would a disposable vape or a traditional cigarette. There are no buttons to press.

No buttons, no setup. The BM600 is draw-activated. Inhaling from the mouthpiece switches it on automatically. There is nothing to power on or configure before your first use.

How to Recharge Your BM600

USB-C, 360mAh battery

The BM600 has a built-in 360mAh rechargeable battery. A full charge typically lasts through a complete pod for moderate users. It is worth giving the device a full charge before first use, as it may not arrive at full capacity.

Locate the USB-C port on the base of the device.
Connect a USB-C cable to the port and plug into a suitable power source. A USB-C cable is not included in the box, but any standard USB-C cable will work.
The LED indicator on the device will light up to show it is charging.
A full charge takes approximately 30 to 60 minutes. The LED will change or turn off when the battery is full.
Disconnect the cable and continue vaping.

Important: Do not vape while the device is charging and do not leave it charging unattended or overnight. Charging at room temperature gives the best battery life over time.

Signs the battery needs charging

Vapour production feels weaker than usual
The LED indicator blinks or turns red during use
The device stops activating when you inhale

Battery or pod? If performance drops, charge the device first before replacing the pod. A low battery is often the cause of weak vapour, and a fresh pod will not fix it if the battery is flat.

Replacing Your Pod

When and how to swap

Each BM600 pod delivers up to 600 puffs, though this varies with draw length and frequency. Replace the pod when you notice any of the following, after first confirming the device has a full charge:

Flavour becomes noticeably weaker or tastes stale
Vapour production drops even after a full charge
You get a burnt or dry taste when inhaling

To replace the pod, pull the old one straight out from the top of the device and dispose of it responsibly. Insert a new pod until the magnets click it into place, then inhale as normal.

BM600 pods only. The Lost Mary BM600 Pod Kit is only compatible with official Lost Mary BM600 prefilled pods. Other pods will not fit correctly and may damage the device.

Shop Lost Mary BM600 replacement pods View the Lost Mary BM600 Kit

Disposing of Used Pods

Used BM600 pods contain e-liquid residue and a small metal mesh coil, so they should not go into general household waste. Take them to a local vape shop or an electrical waste (WEEE) recycling point.