How to set up your Lost Mary BM6000Updated a month ago

Lost Mary BM6000 prefilled pod kit setup steps overview

The Lost Mary BM6000 Prefilled Pod Kit delivers up to 6,000 puffs from a single refill pack. Each pack contains a 2ml prefilled pod and a 10ml e-liquid container, giving you 12ml of 20mg nicotine salt e-liquid in total. A 1,000mAh rechargeable battery, OLED battery display, and draw-activated firing make it one of the most straightforward big-puff kits available. There are no buttons, no manual filling, and no coil changes.

Get Set Up in 4 Simple Steps

The whole process takes under 10 minutes

Remove and read the sticker
Peel the instruction sticker from the device and read it carefully before doing anything else. Also remove the air hole cover from the side of the device, as leaving it on will prevent the device from firing.
Insert the container into the device
Push the 10ml e-liquid container firmly into the side of the device until you feel it click into place. Hold the device upright while doing this to avoid any liquid spillage.
Turn the device upside down to fill
Flip the device upside down. This allows e-liquid to gravity-feed from the 10ml container down into the 2ml pod at the top. Keep it inverted for around 10 seconds, or until you can see liquid bubbling through the pod window.
Important: Allow at least 5 minutes for the coil to fully soak up the e-liquid before taking your first puff. Skipping this step can burn the coil and ruin the flavour for the entire pod.
Puff to vape
Remove the silicone stopper from the mouthpiece, then simply inhale to begin vaping. The BM6000 is draw-activated, so no buttons are needed.

Checking Your Battery and E-Liquid Level

The BM6000 has two ways to monitor your device at a glance. The OLED screen on the front shows your exact battery percentage, so you always know when a charge is needed rather than guessing from a blinking light. The transparent window on the side of the container lets you see how much e-liquid remains in the 10ml reservoir.

Top tip. The OLED screen shows battery percentage, not e-liquid level. Keep an eye on both the screen and the window to stay ahead of both running out at the same time.

How to Recharge Your BM6000

USB-C, 1,000mAh battery

The 1,000mAh battery is large enough for a full day of moderate vaping before needing a charge. Charge it when the OLED screen drops below 20% to keep flavour and vapour consistent throughout each session.

Locate the USB-C port on the base of the device.
Connect a USB-C cable to the port and plug into a suitable power source. A USB-C cable is not included in the box, but any standard USB-C cable will work.
The OLED screen will show the battery percentage increasing as it charges.
A full charge takes approximately 1 to 2 hours. The screen will show 100% when complete.
Disconnect and continue vaping.

Important: Do not vape while the device is charging and do not leave it charging unattended or overnight. Charge at room temperature for the best battery lifespan.

Charging but nothing happening? Some USB-C cables only transfer data and cannot charge devices. If the screen does not respond, try the cable from your phone or another device you know charges reliably.

Replacing Your Refill Pack

When and how to swap

Each refill pack delivers up to 6,000 puffs, though draw length and frequency will affect this. Most moderate users get between 3 and 7 days per pack. Replace the refill pack when you notice any of the following, after first confirming the device has a full charge:

The e-liquid window shows the container is empty
Flavour becomes noticeably weaker or tastes stale
Vapour production drops even on a full battery
You get a dry or burnt taste when inhaling

To replace the refill pack, pull the empty container and pod out from the device. Insert a new refill pack, flip the device upside down for 10 seconds to fill the pod, and wait 5 minutes before vaping again.

BM6000 refill packs only. The BM6000 is only compatible with official Lost Mary BM6000 refill packs. Other pods will not fit correctly and may damage the device.

Shop Lost Mary BM6000 replacement pods View the Lost Mary BM6000 Kit

Disposing of Used Refill Packs

Used refill packs contain e-liquid residue and a mesh coil, so they should not go into general household waste. The BM6000 has a detachable battery unit, which means the battery can be separated from the device body and taken to a WEEE electrical recycling point independently. Take used pods and the battery unit to a local vape shop or council recycling facility.