How to Use the Elf Bar 600 Prefilled Pod KitUpdated 2 days ago
The Elf Bar 600 Prefilled Pod Kit is a rechargeable, draw-activated device designed to work straight out of the box. Each prefilled pod contains 2ml of 20mg nicotine salt e-liquid and delivers up to 600 puffs. There are no buttons, no settings, and no refilling.
Get Set Up in 3 Simple Steps

- Remove all packaging from both the device and the pod.
- Insert the pod into the top of the device until it clicks into place.
- Inhale as you would a disposable vape or a traditional cigarette. No button press needed.
Charging Your Device
USB-C, rechargeable battery
Unlike a standard disposable vape, the Elf Bar 600 has a built-in rechargeable battery. When the device feels weak or vapour production drops, charge it before replacing the pod.
- Locate the USB-C port on the base of the device.
- Connect a USB-C cable to the port and plug into a power source. A cable is not included, but any standard USB-C cable will work.
- A full charge takes approximately 30 to 90 minutes. The LED indicator will change or turn off when charging is complete.
- Disconnect and continue vaping.
Replacing Your Pod
When and how to swap
Each pod lasts up to 600 puffs, though this varies depending on how long your draws are. Replace the pod when you notice any of the following:
- Flavour becomes noticeably weaker or tastes stale
- Vapour production drops even after a full charge
- You get a burnt or dry taste when inhaling
- The LED indicator blinks or stops responding
To replace the pod, pull the old one straight out from the top of the device and discard it responsibly. Insert a new pod until it clicks firmly into place, then inhale as normal.
Disposing of Used Pods
Used pods contain a small amount of e-liquid residue and a metal coil, so they should not go in general household waste. Take them to a local vape shop or electrical waste recycling point. Many Vape Superstore locations accept used pods and devices for responsible disposal.